Step 1
Parts, in assembly order
🧬
Enter each part 5′→3′, in the order it appears in the finished construct. A part shorter
than the fold-in threshold (default 50 bp) isn't PCR'd on its own — it gets built into the
neighbouring primer's tail instead. Attach the source plasmid to any part you PCR out of a
larger plasmid: that is what lets the off-target check see the whole template, not just your insert.
Step 1a
The plasmid you want to end up with
Step 1b
plasmids on your shelf, gBlocks, gDNA…
Templates you'll PCR from
🔍
Paste every plasmid that might contribute a piece. Each region of your target gets traced back
to the template it came from, on either strand, wrapping the origin if needed — then the primers
for that region are screened against that entire template, so a primer that would also stick
somewhere else in the same plasmid is caught before you order it.
Step 2
Which enzyme and kit are you using?
Opens on top — you rarely need it while designing.
Fine-tune primer & overlap rules (sensible defaults already set from the manual)
Primer binding region
Every primer aims here, so the whole set runs at one annealing temperature.
Never knowingly go above this; flagged honestly if the sequence can't avoid it.
A mismatched pair is the classic cause of one primer working and the other not.
18–30 nt standard, 20 ideal. Tm match wins if they conflict.
Gibson overlap (homology arm)
20 bp is the accepted floor at 50 °C; it searches longer automatically to escape a repeat.
Stops one primer getting a near-zero tail when the overlap is split.
The arms must stay annealed at the 50 °C reaction temperature.
Conditions & specificity screen
A site with this many mismatches or fewer still counts as a real risk, not just exact repeats.
Parts below this ride along in a primer tail instead of being PCR'd.
Above 60 nt, order PAGE/HPLC-purified.